Electronic Ignition Conversion Kit
for 4-cylinder
Alfa-Romeo Alfetta, Alfetta GT,
2000 Berlina GT & Spider Veloce,
Alfasud, TI, 5M, Sprint,
Romeo F12 (Versolone Benzina), GTV 2000
Replaces Points and Condenser - Never Adjust Points or Timing Again!
The Hot-Spark electronic ignition conversion kit replaces breaker points and condenser in the distributor to provide rock-solid reliability. With the Hot-Spark electronic ignition, dwell and timing are always spot-on accurate.
No matter how strong your engine is, you won't get the most out of it without a good spark. The stock Bosch ignition system used technology that dates back a century - to the Kettering system, which was introduced in the 1910 Cadillac. Even though you can adjust breaker points for near-electronic ignition performance, they will burn and wear within a few thousand miles, long before the recommended replacement interval. With points, the timing will drift; power and fuel economy will suffer.
The Hot-Spark electronic ignition conversion kit delivers a strong spark every time and is maintenance-free. You'll notice quicker starts, more top end power and a little gas mileage boost. It's as easy to install as points and condenser!
Advantages of the Hot-Spark electronic ignition conversion kit:
Replaces points and condenser with solid-state electronics
Set it and forget it - Never adjust points and timing again!
Zero maintenance
Delivers far more voltage to the spark plugs than contact breaker points
Reliable Hall-effect technology
Never gets out of adjustment
Rock-steady reliability
Dwell and timing are always spot-on accurate
Increased gas mileage, fuel economy
Quick starting
Smooth idling
Cleaner emissions
Longer spark plug life
Longer engine life
Cleaner engine oil due to less unburned fuel
Longer interval between oil changes
Easy to install - If you can install points, you can install the Hot-Spark electronic ignition conversion
No points to wear, burn, pit or corrode
No condenser needed
Absolutely no points float - zero - even at redline RPM and beyond!
Never worry about drifting dwell or timing again
No rubbing parts - nothing to wear out!
Fits completely under the distributor cap
Stealth modification - maintains stock appearance
Includes everything you need - no external ignition box required.
Works with stock distributor and coil
Encased in high-temp thermoplastic - protected from the elements and oil, grease, dirt, water, etc.
Never bother with points or condenser again!
The best investment you'll ever make for your vehicle
Saves precious ($$$) gasoline/natural gas/propane, etc.
Coil with 1.5 Ohms or more internal, primary resistance required. Stock Bosch coil or HS15HEC high-energy coil OK.
How many miles until the Hot-Spark electronic ignition conversion kit pays for itself? Click here
Three-year replacement warranty
The Hot-Spark electronic ignition
conversion kit is as easy to install as points and
condenser!
For:
4-cylinder Bosch distributor with
right-hand pivot pin, one-piece points - 3BOS4U1
4-cylinder Bosch distributor with left-hand
pivot pin, one-piece points - 3BOS4U1L
4-cylinder, non-vacuum-advance Bosch distributor with
right-hand
pivot pin, two-piece points - 3BOS4C2
Sorry, we don't currently have
ignition kits for Marelli distributors.
Left-hand (at left) and Right-hand Pivot Pin, One-piece Contact Breaker
Points
Determine whether your Bosch distributor has
one-piece or two-piece points, as older (pre-1968 or so) distributors
typically have two-piece points. If it has two-piece points, a pivot pin will
remain, standing upright from the breaker plate, after the points have been
removed.
Alfa-Romeo
1969-81 All 4-cyl: Alfetta, Alfasud, Berlina, Giulietta, Giulia, Spider, Sprint Veloce, Arna
(except Ducellier distributor) - 3BOS4U1
1971-75 Alfetta, Alfetta GT, 2000 Berlina GT & Spider Veloce
- 3BOS4U1
Vehicles with centrifugal-advance-only Bosch
4-cylinder distributor with one-piece, right-hand points - 3BOS4U1
Vehicles with centrifugal-advance-only Bosch
4-cylinder distributor with two-piece, right-hand points - 3BOS4C2
1966-68 4-cyl Giulia, Spider - Bosch 0 231 100 041 (with 2-piece, right-hand
points) - 3BOS4C2
1967-68 4-cyl Sprint GT, Veloce - Bosch (with 2-piece, right-hand points) -
3BOS4C2
1975-78 Alfasud, TI, 5M, Sprint - 3BOS4U1
1976-78 Romeo F12 (Versolone Benzina) - 3BOS4U1
1977-81 Alfetta 1.6, 1.8, 2.0 Litre - 3BOS4U1
1977-81 GTV 2000 - 3BOS4U1
|
(supersedes 3BOS4V1) Easy to Install - Replace Points and Condenser with Solid-State Electronics |
Electronic Ignition Conversion Kit. Replaces points and condenser in many Bosch
4-cylinder distributors, including VW, Porsche, Volvo-Penta marine engines,
BMW, Alfa-Romeo, Volvo, Saab, etc. Fits 4-cylinder Bosch vacuum-advance and
centrifugal-advance-only distributors with one-piece, right-hand pivot pin
points.
For Distributors:
4-cylinder Bosch
distributors with one-piece, right-hand pivot pin points
For centrifugal-advance and vacuum-advance
distributors Application:
VW, Porsche, BMW, Alfa-Romeo,
Mercedes-Benz, Audi, Volvo, Volvo-Penta, Opel, Saab, etc.
12V
negative ground only
Coil Required:
Stock Bosch coil or
HS15HEC
high-energy
coil OK. Coil should have 1.5 Ohms or more primary resistance. In stock:
Available:
|
||||||||||||||
|
|||||||||||||||
|
1.5 Ohms primary resistanceminimum of 12K Ohms secondary resistance |
||||||||||||
|
High secondary resistance for more voltage at the plugs Ideal for Use with Hot-Spark Electronic Ignition Conversion Kits with red ignition module
|
Heavy-duty, high-energy coil with extra turns of copper wire in the
secondary windings for as much as 50,000 volts to the spark plugs - more
turns of copper wire than other standard-sized canister coils.
Application:
Designed specifically to produce maximum spark
when used
with Hot-Spark red electronic ignition conversion kits
(red ignition module).
Also for points-based ignition systems
Epoxy-filled
canister (not oil-filled) to withstand high-vibration
environments
Rugged, mirror-polished stainless steel case -
won't chip or peel like chrome-plated aluminum coil canisters.
Standard 56mm (2.2 in.) coil
diameter - fits stock coil clamps.
In Stock:
Available:
|
|||||||||||
|
||||||||||||
|
Easy to Install - Replace Points and Condenser with Solid-State Electronics |
Electronic Ignition Conversion Kit. Replaces points and condenser in certain Bosch
4-cylinder, non-vacuum-advance distributors with two-piece, right-hand pivot pin
points.
For Distributors:
4-cylinder, non-vacuum-advance Bosch
distributors with two-piece, right-hand pivot pin points.
For centrifugal-advance-only distributors. Not for
vacuum-advance distributors. Also available in 6-cylinder
version (3BOS6C2). Application:
Certain VW, Porsche, BMW, Alfa-Romeo,
Mercedes-Benz, Volvo, Volvo-Penta, etc., with
non-vacuum-advance distributors with 2-piece points, including
these Bosch distributors:
0 231 100 041
VJ4BR8
VJR4BR9
VJR4BR11
If a Bosch distributor has two-piece points, an upright pivot
pin will remain, standing up from the breaker plate, after the
points have been removed.
12V
negative ground only
Coil Required:
Stock Bosch coil or
HS15HEC
high-energy
coil OK. Coil should have 1.5 Ohms or more primary resistance. In stock:
Available:
|
||||||||||||||
|
|||||||||||||||
Email us for more information.
Foreign Orders: Shipping discount available if purchasing multiple items.
We accept payment via www.PayPal.com - Our PayPal ID is Sales@Hot-Spark.com .
Click here for Hot-Spark Ignition Installation Instructions
Just a better idea.
TM
© 2005 Hot-Spark
Ignition Products